Note
Access to this page requires authorization. You can try signing in or changing directories.
Access to this page requires authorization. You can try changing directories.
Currently, we have no script to rebuild WMI in Windows 7 client. Following is the procedure to rebuild WMI in Windows 7.
1) Perform a manual logcopy on the PC.
2) Open an elevated command prompt.
3) Verify the WMI repository is not corrupt by running the following command:
winmgmt /verifyrepository
If the repository is not corrupted, a “WMI Repository is consistent” message will be returned. If you get something else, go to step 4.
4) Run the following commands:
winmgmt /salvagerepository
If the repository salvage fails to work, then run the following command to see if it resolves the issue:
winmgmt /resetrepository
After the last command, there should be a “WMI Repository has been reset” message returned.
NOTE: We always use winmgmt /resetrepository to repair the WMI in the Windows 7 client.
Comments
- Anonymous
January 01, 2003
Thank you very much for sharing this!